Nokta-detectors Golden Sense Quick Guide Manuel d'utilisateur télécharger pdf

QUICK GUIDE

GROUND BALANCE

Rotate the

sensitivity knob

to maximum

and the ground

balance knob to

the mid-level.

If the detector emits false signals due to interference,

reduce the sensitivity until the signals go away and

start searching.

Sensitivity is also the depth setting for the device.

Therefore, it is recommended that you do not lower it

too much suddenly but gradually decrease it to

determine the level where you are not getting any

interference and continue searching.

Holding the search coil 5cm.

above the ground, sweep it

right and left.

Turn on the device

by setting the

search mode knob

to ALL METAL.

Approximately 20

seconds later, the LEDs

on the handle will go o

and you will hear a tone

indicating that the device

is ready to use.

When the device detects a metal, it will produce an audible tone. For pinpointing the exact location of the target, move the search coil

over the target with short and faster/slower sweeps.

The most important thing to pay attention here is that as the ground balance goes into the right area, the device will start losing depth

for some non-ferrous metals except for gold. When the ground balance setting reaches the maximum point the device will detect iron

and gold but it will not detect some non-ferrous metals.

3) RIGHT AREA: Is used to eliminate high mineralized rocks and soils. If you are on a highly mineralized ground and the device is still getting

ground noise with the ground balance set at mid-level, turn the ground balance knob to the right in very small increments to eliminate the

noise.

Golden Sense ground balance setting consists of 3 dierent levels:

1) MID-LEVEL: Oers the most ideal and stable detection capability on dierent types of

grounds without sacrificing depth.

2) LEFT AREA: Recommended for more precise detections and for experienced users.

The device may generate false signals in changing ground conditions, even over holes

dug for testing. Therefore, if you set the ground balance in this area, you have to take

this factor into consideration.

After the ground balance and

sensitivity settings are

adjusted, you can start

searching by lifting the search

coil 5cm. above the ground and

sweeping it right and left,

keeping it parallel to the

ground.

To avoid missing smaller and

deeper targets, sweep the

search coil both from right to

left and left to right over each

area you are scanning, slightly

overlapping the sweeps as you

move forward.

GROUND BALANCE

2) LEFT AREA

3) RIGHT AREA

1) RECOMMENDED SETTING

MID-LEVEL

SENSITIVITY

TURNING ON THE DEVICE

SENSITIVITY SETTING

SEARCHING AND METAL DETECTION

1 2

QUICK GUIDE 1

Résumé du contenu

Page 1 - QUICK GUIDE

QUICK GUIDEGROUND BALANCERotate the sensitivity knob to maximum and the ground balance knob to the mid-level.If the detector emits false signals due t

Page 2

Insert the coil cable into the shaft. Do not extend the shaft prior to this step! Pull the cable out from the other end of the shaft.Coil cover use is

Plus de documents pour Sports et loisirs Nokta-detectors Golden Sense Quick Guide

Voir le document Nokta-detectors Golden Sense Quick Guide Manuel d'utilisateur

Nokta-detectors Golden Sense Quick Guide Manuel d'utilisateur (2 pages)

Commentaires sur ces manuels

Pas de commentaire

Nokta-detectors Golden Sense Quick Guide Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Sports et loisirs Nokta-detectors Golden Sense Quick Guide. Nokta detectors Golden Sense Quick Guide User Manual Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Sports et loisirs Nokta-detectors Golden Sense Quick Guide

Commentaires sur ces manuels

Produits connexes et manuels pour Sports et loisirs Nokta-detectors Golden Sense Quick Guide