Nokta-detectors Golden Sense User Manual Manuel d'utilisateur télécharger pdf (Page 20)

NOKTA ENGINEERING19

SEARCHING AND METAL DETECTION

5cm

SEARCHING AND METAL DETECTION

PINPOINTING

After the ground balance and senstvty settngs are adjusted, you can start searchng by lftng the

search col 5cm. above the ground and sweepng t rght and left, keepng t parallel to the ground.

NOTE: You may have to re-adjust the senstvty and ground balance settngs whle searchng because

as you change your locaton there may be changes n the ground or surroundng electromagnetc

nterferences as well. Therefore, you may need to repeat the above processes should your devce starts

recevng nterference or nose.

To avod mssng smaller and deeper targets, sweep the search col both from rght to left and

left to rght over each area you are scannng, slghtly overlappng the sweeps as you move

forward.

When the devce detects a metal, t

wll produce an audble tone. If the

devce s n dscrmnaton mode,

the LEDs on the handle wll lght up

at the same tme.

For pnpontng the exact locaton of the target, move the

search col over the target wth short and faster/slower

sweeps.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Nokta-detectors Golden Sense User Manual Manuel d'utilisateur Page 20